 |
STC «Promprilad»:
Ukraine, 04080, Kyiv-080, P.B. 43
phone/fax: (044) 467-51-38,
467-51-39
EMail: ndt@ln.com.ua
Dynamic hardness gauge TDM-1 (release 1.5) is intended for high-speed measurements and hardness inspection of the structural, carbon and stainless steels and nonferrous metals made alloys, based on methods of Rockwell, Brinell, Vickers, Super-Rockwell, Shore and Leyb.
The dynamic hardness gauge is a compact device of TDM-2 type that is intended for express non destructive measurements and inspection of hardness of the structural, carbon steel and stainless steels and alloys made of nonferrous metals based on the Rockwell and Brinell scales.
Special-purpose eddy current flaw detector ВД-30НК-IVE is designed for detecting surface cracks in components made of ferromagnetic materials with rough-turned plate and curved surface
Densitometer for radiographic films entitled "Expert", is designed for measuring optical density of industrial radiographic films used during radiographic inspections of facilities.
Ultrasonic flaw detector UD3-71 is intended for defects detection, such as discontinuity and irregularities in materials, end items, semi-products and welded (soldered) joints; for the measurement of the flaw depth and coordinates; for the measurement of echo signals amplitude ratio; for the equivalent size measurement.
The flaw detector МД-4П (МД-4К) is designed for detecting surface flaws of discontinuity type in metals by means of the magnetic particle technique on the local sections of large-size components through originating stationary magnetic field applied.
Set of lenses with backlighting KLP-5 represents a power unit with a switch where the lenses with various magnification levels may be installed. The designed lens and the lamp are combined into one single device and may be easily replaced.
|
|
|
|
|
Flaw detector UD3-71 Is intended for defects detection, such as discontinuity and irregularities in materials, end items, semi-products and welded (soldered) joints; for the measurement of the flaw depth and coordinates; for the measurement of echo signals amplitude ratio; for the equivalent size measurement.
Specific features:
- Fully functional ultrasonic flaw detector;
- Fully functional A-Scan thickness gauge;
- Defect equivalent size measurement;
- Two independent measurement gates;
- Two independent flaw gates;
- DGS (AVG) diagram mode;
- Precise measurement of thickness and flaw coordinates;
- RF display mode;
- Setup programs and test results memorizing;
- "Electronic lens" mode;
- "Freeze frame";
- Display backlighting;
- PC interface mode;
- Inspection procedure recording with "Ultra UD3-71" software (Russian interface)
Main technical specifications:
Operating frequencies | 0.4...15 MHz |
Inspection range (on steel) | 0...300 mm |
Gain | 0-80 dB |
Absolute error when measuring the Hx flaw occurrence depth | ±(0.1...0.005 Hx) mm |
Absolute error when measuring the Nx signal range ratio | ±(0.2...0.03 Nx) dB |
Time of continuous operation powered from batteries | at least 24 hours |
Weight | 0.4 kg |
Dimensions | 105х190х80 mm | |
|
|
|
|
|
|
|
|
|
